We have changed our name from Sound Isolation Store to IsoStore. Same great service and products, just a new domain! Please update your bookmarks and contact information.

Find Products By Use

Select a category below to find the best solution to your sound problems.
More detailed responses to the suggestions below can be found in the Research > Solutions section.

Crucial: Reduce Ceiling Flanking

Ceilings often have the most flanking paths due to lighting, plumbing, duct, gaps in the sub-floor above, soffits, ceiling fans, etc. The products listed below have proven to isolate these flanking paths with ease and minimal cost.

View Products

Acoustical Sealant Tubes

Sound isolation products will not perform as advertised if the assembly is not well sealed. Even small gaps will allow significant amounts of noise to pass through. Seal these gaps with a quality acoustical sealant product.

  • $98.00
    Case of Acoustical Sealant
  • $8.50
    Tube of Acoustical Sealant
  • $25.00
    Green Glue Caulking Gun

QuietBox

Recessed lights represent a major loss of mass, allowing nearly direct sound transfer if left untreated. Our QuietBox can be installed in both resilient or rigid ceilings and perform for zero loss.

$39.00

GenieClip LB

Ceiling fans, projectors, soffits, and other heavy items hanging from the ceiling can be attached to wood blocks and the blocks can then be decoupled using the GenieClip LB.

$6.50

VibraDamp

Plumbing pipes and sheet metal duct will resonate easily because they are lightweight materials. VibraDamp will dampen these surfaces very efficiently. Wrapping the drain pipe will also eliminate pipe noise which is a nuisance in most any type of room.

$11.00

SpecSeal SSP Putty Pad

Putty pads are needed when there are more than two single gang outlets within a 100 square foot space. Other uses are for various electrical outlets, around the perimeter of door jambs or window frames, and any large gap thicker than 3/8".

$25.00

Fantech FG Centrifugal Fan

This airtight centrifugal fan is used in a couple assembly drawings we created to isolate HVAC duct. Follow these drawings and the duct will be fully isolated without restricting airflow.

  • $125.00
    Fantech FG 4
  • $205.00
    Fantech FG 6XL

Crucial: Reduce Wall Flanking

Walls typically have fewer flanking paths than ceilings. Without treating these flanking paths and fully sealing the walls, the performance of any sound isolation product will be reduced significantly.

View Products

Acoustical Sealant Tubes

Sound isolation products will not perform as advertised if the assembly is not well sealed. Even small gaps will allow significant amounts of noise to pass through. Seal these gaps with a quality acoustical sealant product.

  • $98.00
    Case of Acoustical Sealant
  • $8.50
    Tube of Acoustical Sealant
  • $25.00
    Green Glue Caulking Gun

GenieClip LB

The wall height can be framed short of the joists and the top plate framing can be fastened resiliently to the joist using the GenieClip LB. This decoupling will significantly reduce transfer from the wall framing to the joists above.

$6.50

SpecSeal SSP Putty Pad

Putty pads are needed when there are more than two single gang outlets within a 100 square foot space. Other uses are for various electrical outlets, around the perimeter of door jambs or window frames, and any large gap thicker than 3/8".

$25.00

VibraDamp

Plumbing pipes and sheet metal duct will resonate easily because they are lightweight materials. VibraDamp will dampen these surfaces very efficiently. Wrapping the drain pipe will also eliminate pipe noise which is a nuisance in most any type of room.

$11.00

Iso-Sill

Used under the bottom plate or above the top plate framing to reduce flanking transfer to the structure. Simple installation and a low cost improvement to any wall.

  • $35.00
    Iso-Sill
  • $1.75
    Iso-Sill Bushing